Translations:Sketcher CreateFillet/6/en
- There are several ways to invoke the tool:
- Press the Create fillet button.
- Select the Sketcher → Sketcher geometries → Create fillet option from the menu.
- Right-click in the 3D view and select the Create fillet option from the context menu.
- Use the keyboard shortcut: G then F, then F.
- If there is a previous selection it is cleared. The tool does not accept a pre-selection.
- The cursor changes to a cross with the current tool mode icon.
- The Fillet/Chamfer parameters section (introduced in version 1.0) is added at the top of the Sketcher Dialog.
- Optionally press the U key or uncheck the Preserve corner checkbox to disable that option. introduced in version 1.0
- Optionally press the M key or select from the dropdown list in the parameters section to change the tool mode:
- Do one of the following:
- Pick a point with a Coincident constraint connecting two non-parallel straight edges.
- Pick two non-parallel edges. Either edge can be a straight line, an arc, an arc of ellipse, an arc of hyperbola or an arc of parabola. B-splines are currently not supported.
- The fillet or chamfer is created, including a point object in case of a preserved corner. For a chamfer a construction geometry arc is also created.
- This tool always runs in continue mode: optionally keep selecting points and/or edges.
- To finish, right-click or press Esc, or start another geometry or constraint creation tool.