Translations:Scripted Parts: Ball Bearing - Part 2/3/en

From FreeCAD Documentation

Workflow

The workflow is more or less identical how you would create the part in part design workbench.
Just some small differences.

  • Create a new empty document and make it the active document
  • Draw the basic shape of the outer ring consisting of four straight lines and four arcs

  • Connect the lines and arcs and upgrade them to one single wire
  • Upgrade the wire to a face
  • Revolve the face to get a shape
  • Draw a circle
  • Upgrade circle to wire
  • Upgrade wire to face
  • Revolve face and apply boolean cut to obtain groove in outer ring
  • Draw the basic shape of the inner ring consisting of four straight lines and four arcs
  • Connect the lines and arcs and upgrade them to one single wire
  • Upgrade the wire to a face
  • Revolve the face to get a shape
  • Draw a circle
  • Upgrade circle to wire
  • Upgrade wire to face
  • Revolve face and apply boolean cut to obtain groove in inner ring
  • Insert balls with same workflow as in part 1 (because of effectiveness)
  • Set view to axometric
  • Zoom to fit all