Translations:Reinforcement UShapeRebar/6/en

From FreeCAD Documentation
  1. Select any face of a previously created Arch Structure object.
  2. Then select U-Shape Rebar from the rebar tools.
  3. A task panel will pop-out on the left side of the screen as shown below.
  4. Select the desired orientation.
  5. Populate the inputs like 'Left Cover', 'Right Cover', 'Top Cover', 'Bottom Cover', 'Front Cover', 'Bent Angle', 'Bent Factor', 'Rounding' and 'Diameter' of the rebar.
  6. Select the mode of distribution either 'Amount' or 'Spacing'.
  7. Pick Selected Face is used to verify or change the face for rebar distribution.
  8. Click OK or Apply to generate the rebars.
  9. Click Cancel to exit the task panel.