From FreeCAD Documentation
- Creează un element structure
- Select any face of the structure
- Then select Stirrup Rebar from the rebar tools
- A task panel will pop-out on the left side of the screen as shown below
- Select the desired orientation
- Give the inputs like left cover, right cover, top cover, bottom, front cover, bent angle, bent factor, rounding and diameter of the rebar
- Select the mode of distribution either amount or spacing
- If spacing is selected, a user can also opt for custom spacing
- Pick selected face is used to verify or change the face for rebar distribution
- Click OK or Apply to generate the rebars
- Click pe Cancel ieșirea din task panel