Translations:Part Sweep/16/ro

From FreeCAD Documentation

Cum se folosește

  1. Apăsați butonul Sweep. Acesta deschide parametrii Sweep în Tasks panel.
  2. In the Available Profiles left column (previously Vertex/Edge/Wire/Face in v0.16), click on the element to be used as sweep profile, then click on the right arrow to place it in the Selected profiles right column (previously Sweep in v0.16). Repeat if more than one profile is desired. Use the up and down arrows to reorder the selected profiles.
  3. Click on the Sweep Path button, then choose either mode of selection:
    • Single segment selection: select one or more contiguous edges in the 3D view (press CTRL for multiple selection) and click Done. The sweep will only be generated along the selected edges.
    • Complete path selection: switch to the Model tab, select the 2D object to be used as path in the tree, switch back to the Tasks pane and click Done. The sweep will be generated along all the contiguous edges found in the 2D object.
  4. Definiți opțiunile Solid și Frenet.
  5. Click OK.