Translations:PartDesign Bearingholder Tutorial I/36/ro

From FreeCAD Documentation
Fillet where the bolts will go

Puteți rotunji primul set. Începeți cu rotunjirea cu raza mică de 4mm. Even though 3mm would be enough as per specification of the part, a radius of 4mm means that after machining 1mm of the fillet is left, reducing the sharp edge produced by the machining. The large fillets are 6mm radius to help spread the force from the bolts into the rest of the part. It would be nice to make this radius even larger, but unfortunately OpenCascade can't handle overlapping fillets yet.