Translations:Manual:Traditional 2D drafting/15/en

From FreeCAD Documentation
  • That is all we need now, so we can switch construction mode off. Check that all the construction geometry has been placed into a "Construction" group, which makes it easy to hide it all at once or even delete it completely later on.
  • Now let's draw our two wall pieces using the Wire tool. Make sure the intersection snap is turned on, as we will need to snap to the intersections of our lines and rectangles. Draw two wires as follows, by clicking all the points of their contours. To close them, either click on the first point again, or press the Close button: