Translations:Manual:Traditional 2D drafting/13/en

From FreeCAD Documentation
  • We can then draw a couple of vertical lines to define where our doors and windows will be placed, using the Line tool (note that the "relative" mode box should be unchecked for this step). The crossing of these lines with our two rectangles will give us useful intersections to snap our walls to. Draw the first line from point (15cm, 1m, 0) to point (15cm, 3m, 0).
  • Duplicate that line 5 times, using the Move tool with Copy mode turned on. Turn also the Relative mode on, which will allow us to define movements in relative distances, which is easier than calculating the exact position of each line. Perform each move operation in sequence on the line that was created immediately prior. Give each new copy any start point, you can leave it at (0,0,0) for example, and the following relative endpoints:
    • line001: x: 10cm
    • line002: x: 120cm
    • line003: x: -55cm, y: -2m
    • line004: x: 80cm
    • line005: x: 15cm