Translations:Macro FCSpring Helix Variable/6/en

From FreeCAD Documentation
  • 10 coils Number of coil : Total of coil to spring. Default = 10
  • 20,000 mm Radius of spring : Radius of spring. Default = 20.0
  • 15,000 mm Pitch of spring : Pitch of spring general. Default = 15.0
  • 5 ( 72 points ) Precision of turn : Precision of turn the precision correspond the number of point for 1 turn the coil and is calculate : precision (number points) = (pitch / (360/precision)). Default = 5 (72 points)
  • 20,000 mm  : Radius of large circle of the cone (check the Spring conical for use)
  • Spring conical : Give the large diameter of the cone that dimension will always be greater than the radius
  • Angles : Check box choice for activate the function Begin and End angle of the coil unchecked by default.
    If the function is checked. The accuracy is automatically set "precision" is ordered 1 ( 360 points ) to 1 (360 points per turn 1 point = 1 degrees)
  • 0 deg Begin : Begin angle of the spring first coil.
  • 360 deg End : End angle of the spring last coil.