Translations:Draft Snap Near/3/en

From FreeCAD Documentation
  1. Make sure snapping is enabled. See Draft Snap Lock.
  2. If Draft Snap Near is not active do one of the following:
    • Press the button in the Draft snap toolbar.
    • Hold down the button in the Draft snap widget and in the menu that opens select the Snap Near option.
  3. Choose a Draft or Arch command to create your geometry.
  4. Note that you can also change snap options while a command is active.
  5. Move the cursor over a face or edge.
  6. The face or edge is highlighted.
  7. If a nearest point is found the point is marked.
  8. Optionally move the cursor along the face or edge to select a different nearest point.
  9. Click to confirm the point.