Translations:Draft Snap Angle/3/en

From FreeCAD Documentation
  1. Make sure snapping is enabled. See Draft Snap Lock.
  2. If Draft Snap Angle is not active do one of the following:
    • Press the button in the Draft snap toolbar.
    • Hold down the button in the Draft snap widget and in the menu that opens select the Snap Angle option.
  3. Choose a Draft or Arch command to create your geometry.
  4. Note that you can also change snap options while a command is active.
  5. Move the cursor over a circular edge.
  6. The edge is highlighted.
  7. If a cardinal point is found the point is marked and the icon is displayed near the cursor.
  8. Optionally move the cursor closer to another cardinal point to select that point instead.
  9. Click to confirm the point.