Translations:Draft BezCurve/5/ro

From FreeCAD Documentation

!!FUZZY!!* Apăsați tasta F sau butonul Finish pentru a finaliza funcția B spline, lăsând-o deschisă

  • Press C or the Close button or click on the first point to finish the spline, but making it closed by adding a last segment between the last point and the first one.
  • Press X, Y or Z after a point to constrain the next point on the given axis.
  • To enter coordinates manually, simply enter the numbers, then press ENTER between each X, Y and Z component.
  • Press R or click the checkbox to check/uncheck the Relative button. If relative mode is on, the coordinates of the next point are relative to the last one. If not, they are absolute, taken from the (0,0,0) origin point.
  • Press T or click the checkbox to check/uncheck the Continue button. If continue mode is on, the BezCurve tool will restart after you finish or close it, allowing you to draw another one without pressing the BezCurve button again.
  • Press CTRL while drawing to force snapping your point to the nearest snap location, independently of the distance.
  • Press SHIFT while drawing to constrain your next point horizontally or vertically in relation to the last one.
  • Press W or press the Wipe button to remove the existing segments and start the spline from the last point.
  • Press CTRL+Z or press the Undo button to undo the last point.
  • Apăsați tasta ESC sau butonul Cancel penru a abandona comanda BezCurve .