Translations:Draft BSpline/5/en
Appearance
- To manually enter coordinates enter the X, Y and Z component, and press Enter after each. Or you can press the
Enter Point button when you have the desired values. It is advisable to move the pointer out of the 3D View before entering coordinates.
- Press R or click the Relative checkbox to toggle relative mode. If relative mode is on, coordinates are relative to the last point, if available, else they are relative to the coordinate system origin.
- Press G or click the Global checkbox to toggle global mode. If global mode is on, coordinates are relative to the global coordinate system, else they are relative to the working plane coordinate system.
- Press F or click the Filled1.0 and below or Make faceintroduced in 1.1 checkbox to toggle make face mode. If make face mode is on, the created spline will have DataMake Face set to
trueand have a filled face, provided it is closed and does not self-intersect. A self-intersecting spline with a face will not display properly, for such a spline DataMake Face must be set tofalse. - Press N or click the Continue checkbox to toggle continue mode. If continue mode is on, the command will restart after using
Finish or
Close, or after creating a closed spline by snapping to the first point of the spline, allowing you to continue creating splines.
- Press / or the
Undo button to undo the last point.
- Press A or the
Finish button to finish the command and leave the spline open.
- Press O or the
Close button to finish the command and close the spline. A closed spline can also be created by snapping to the first point of the spline.
- Press W or the
Wipe button to delete the curve segments already placed, but keep working from the last point.
- Press U or the
Set Working Plane button to adjust the current working plane in the orientation defined by the last and the previous point.
- Press S to switch Draft snapping on or off.
- Press Esc or the Close button to finish the command.