Translations:Assembly3 Workbench/80/en
- Sketch plane: Add a "Sketch plane" to define the work plane of any draft element inside or following this constraint.
- Add an empty "Sketch plane" to undefine the previous work plane.
- Line length: Add a "Line length" constrain the length of a non-subdivided Draft.Wire.
- Equal length: Add an "Equal length" constraint to make two lines of the same length.
- Length ratio: Add a "Length ratio" to constrain the length ratio of two lines.
- Length difference: Add a "Length difference" to constrain the length difference of two lines.
- Length Equal Point Line Distance: Add a "Length Equal Point Line Distance" to constrain the distance
- between a point and a line to be the same as the length of a another line.
- ( )Equal Line Arc Length: Add an "Equal Line Arc Length" constraint to make a line of the same length as an arc.
- Mid point: Add a "Mid point" to constrain a point to the middle point of a line.
- Diameter: Add a "Diameter" to constrain the diameter of a circle/arc.
- Equal radius: Add an "Equal radius" constraint to make two circles/arcs of the same radius.
- Points project distance: Add a "Points project distance" to constrain the distance of two points projected on a line.
- Equal point line distance: Add an "Equal point line distance" to constrain the distance
- between a point and a line to be the same as the distance between another point and line.
- Colinear: Add a "Colinear" constraint to make two lines collinear.
- Sketch plane: Add a "Sketch plane" to define the work plane of any draft element inside or following this constraint.