CAM: Usuwanie zadziorów

From FreeCAD Documentation
(Redirected from Path Deburr/pl)
This page is a translated version of the page CAM Deburr and the translation is 28% complete.
Other languages:

CAM: Usuwanie zadziorów

Lokalizacja w menu
CAM → Usuwanie zadziorów
Środowisko pracy
CAM
Domyślny skrót
brak
Wprowadzono w wersji
0.18
Zobacz także
brak

Opis

Narzędzie Usuwanie zadziorów służy przede wszystkim do gratowania krawędzi.

Użycie

  1. There are several ways to invoke the command:
    • Press the Deburr button.
    • Select the CAM → Deburr option from the menu.
  2. The Deburr task panel opens. See Options.
  3. Select Base Geometry.
  4. Specify the required parameters.
  5. Press the OK button.

Options

After selecting the geometry in the Base Geometry section of the task panel you can press Apply to see the tool path as defined by the default options.

Next you can check your depths/step down and heights, just like with other path commands.

The Final step is to activate the Operation section where you can specify the following:

  • Tool controller: Select the tool to use.
  • Coolant Mode: Select None, Flood or Mist.
  • Directions: Select CW (clockwise) or CCW (counter-clockwise).
  • W: The dimension of your edge.
  • h: The offset from the bottom of the tool. It's a safety feature because if the tip gets above the edge it won't cut anymore.
Deburring interface with the options

Properties

Data

Base

  • DANEPlacement:
  • DANELabel: User name of the object (UTF-8)

Deburr

  • DANEDirection: CCW or CW.
  • DANEEntry Point: Entry point of the operation, if set to 2 it will go in 2 corners from the default.
  • DANEExtra depth: Extra depth (h in the task panel).
  • DANE (Hidden)Join: How to join chamfer segments, Round or Miter.
  • DANE (Hidden)Side: Side of the operation, Outside or Inside.
  • DANEWidth: The width of the chamfer (W in the task panel).

Depth

  • DANEClearance Height: The height needed to clear clamps and obstructions (set by default to OpStockZMax + SetupSheet.ClearanceHeightOffset).
  • DANESafe Height: The height above which rapid motions are allowed. (set to OpStockZMax + SetupSheet.SafeHeightOffset).
  • DANEStart Depth: Starting depth of of the tool, first cut depth in Z.
  • DANEStep Down: Incremental step down of the tool.

Op Values

  • DANEOp Stock ZMax: The maximum Z value of the stock.
  • DANEOp Stock ZMin: The minimum Z value of the stock.
  • DANEOp Tool Diameter: The diameter of the tool.

Path

  • DANEActive: Make false, to prevent operation from generating code.
  • DANEBase: The base geometry for this operation, edges or a face.
  • DANEComment: An optional comment for this operation.
  • DANECoolant Mode: Coolant mode for this operation.
  • DANECycle Time: Estimated cycle time for this operation.
  • DANETool Controller: The tool controller that will be used to calculate the path.
  • DANEUser Label: User assigned label.