Fasteners Lochsenkung
Appearance
Dieser Befehl ist veraltet und steht in 0.5.13 und neuer nicht mehr zur Verfügung. Stattdessen sollte das Werkzeug PartDesign Bohrung eingesetzt werden.
|
|
| Menüeintrag |
|---|
| Fasteners → Make countersunk |
| Arbeitsbereich |
| Fasteners |
| Standardtastenkürzel |
| Keiner |
| Eingeführt in Version |
| - |
| Siehe auch |
| Keiner |
Beschreibung
Der Befehl Fasteners Lochsenkung erstellt eine Senkung an einem Loch für Senkschrauben.
Löcher mit Senkung für Senkschrauben
Anwendung
- The command can detect screw diameters automatically. Holes must have the correct diameter for this to work. For example an M5 screw requires a 5mm pass hole or a 4.2mm tap hole. The
Fasteners ScrewCalculator command can be used to determine tap hole diameters.
- Select a part with circular holes.
- There are several ways to invoke the command:
- Press the
Make countersunk button.
- Select the Fasteners →
Make countersunk option from the menu.
- Press the
- The Chamfer holes for countersunk screws task panel opens.
- The Edges to chamfer list shows all circular edges of the selected part.
- Select the edges you want to chamfer by doing one of the following:
- Click individual circular edges or faces with circular edges in the 3D View:
- There is no need to hold down the Ctrl key.
- Each selected edge is checked in the Edges to chamfer list.
- The screw diameter for each edge is detected automatically.
- Edges cannot be deselected in the 3D View.
- Select or deselect edges by checking or unchecking them in the Edges to chamfer list:
- In this case the screw diameter is not detected automatically.
- Click individual circular edges or faces with circular edges in the 3D View:
- Optionally change the screw diameter of individual edges in the Edges to chamfer list by double-clicking their Diameter field, and selecting a new value from the dropdown list that appears.
- Optionally change the screw diameter of all selected edges by selecting a new value from the Diameter dropdown list below the Edges to chamfer list.
- Optionally specify a Screw type.
- Press the OK button.
- A Countersunk object with a chamfered recess for each selected edge is created.
- Optionally attach screws. See Fasteners Workbench.
Hinweise
- Versenkte Objekte sind parametrisch. Ein vorhandenes versenkte Objekt kann durch Doppelklicken in der Baumansicht bearbeitet werden. Das Aufgaben-Fenster Gefaste Löcher für Senkkopfschrauben wird geöffnet. Rundkanten können hinzugefügt oder entfernt werden, und die Parameter der Kanten können geändert werden.
