Translations:Sketcher CreateArcOfHyperbola/6/en

From FreeCAD Documentation
Revision as of 09:25, 18 April 2024 by FuzzyBot (talk | contribs) (Importing a new version from external source)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
  1. There are several ways to invoke the tool:
  2. The cursor changes to a cross with the tool icon.
  3. Pick the center of the major radius of the arc (labelled 1 in the image above).
  4. Pick the vertex of the arc (labelled 2 in the image above), this also defines its major radius.
  5. Pick the start point of the arc (labelled 3 or 4 in the image above), this also defines its curvature.
  6. Pick the endpoint of the arc (labelled 3 or 4 in the image above).
  7. The arc of hyperbola is created, including a set of internal geometry.
  8. If the tool runs in continue mode:
    1. Optionally keep creating arcs.
    2. To finish, right-click or press Esc, or start another geometry or constraint creation tool.