Translations:SheetMetal AddFoldWall/18/en
- Create a blank
- Select the outline sketch
- Press the Make Base Wall button
or use the keyboard shortcut: C then B
(The blank is padded in z direction and so it has to be flipped
each time, to select the bottom face that is lying on the sketch plane)
- Fold the tip
- Select the blank's bottom face
- Select the sketch named Tip Fold line (preferably from the tree view)
(and don't forget the control/command key ) - Press the Fold a wall button
or use the keyboard shortcut: C then F
- The fold should be 90° down and so some values in the properties window need to be set e.g.:
- the angle value to 60°
- the invert value to true for an upward bend
- Create the downward fold
- Select the blank's bottom face
- And then the sketch named Down-Fold line
- Press the Fold a wall button
or use the keyboard shortcut: C then F
- Set the angle value to 92°
- If the wrong section of the part moved set the invertbend value to true
- To create the upward fold
- select the blank's bottom face
- and then the sketch named Up-Fold line
- Press the Fold a wall button
or use the keyboard shortcut: C then F
- Set the angle value to 80°
- If the fold is downward set the invert value to true
- If needed set the invertbend value to true
Done!