Translations:Reinforcement StirrupRebar/6/ru

From FreeCAD Documentation
Revision as of 11:31, 9 March 2024 by FuzzyBot (talk | contribs) (FuzzyBot moved page Translations:Arch Rebar Stirrup/6/ru to Translations:Reinforcement StirrupRebar/6/ru without leaving a redirect: Part of translatable page "Arch Rebar Stirrup")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
  1. Создайте элемент structure
  2. Выберите любую грань структуры
  3. Then select Stirrup Rebar from the rebar tools
  4. A task panel will pop-out on the left side of the screen as shown below
  5. Select the desired orientation
  6. Give the inputs like left cover, right cover, top cover, bottom, front cover, bent angle, bent factor, rounding and diameter of the rebar
  7. Select the mode of distribution either amount or spacing
  8. If spacing is selected, a user can also opt for custom spacing
  9. Pick selected face is used to verify or change the face for rebar distribution
  10. Нажмите OK или Apply, чтобы создать арматуру
  11. Нажмите Cancel, чтобы выйти из панели задач