Translations:PartDesign Pocket/4/en: Difference between revisions

From FreeCAD Documentation
(Neue Version von externer Quelle importiert)
 
(Importing a new version from external source)
 
Line 1: Line 1:
==Limitations==
* Use the type '''Dimension''' or '''Through All''' wherever possible because the other types sometimes give trouble when they are being patterned
* Use the type '''Dimension''' or '''Through All''' wherever possible because the other types sometimes give trouble when they are being patterned
* Otherwise, the pocket feature has the same [[PartDesign_Pad#Limitations|limitations]] as the pad feature.
* Otherwise, the pocket feature has the same [[PartDesign_Pad#Limitations|limitations]] as the Pad feature.

Latest revision as of 09:32, 14 November 2021

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (PartDesign Pocket)
* Use the type '''Dimension''' or '''Through All''' wherever possible because the other types sometimes give trouble when they are being patterned
* Otherwise, the pocket feature has the same [[PartDesign_Pad#Limitations|limitations]] as the Pad feature.
  • Use the type Dimension or Through All wherever possible because the other types sometimes give trouble when they are being patterned
  • Otherwise, the pocket feature has the same limitations as the Pad feature.