Translations:PartDesign Pad/29/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "===Type=== Opcja Type pozwala na wybranie pięciu różnych sposobów określania długości, na jaką Pad będzie wyciągany. ====Dimension==== Podaj długość Pad-u. Domy...")
 
No edit summary
 
(2 intermediate revisions by 2 users not shown)
Line 1: Line 1:
===Type===
===Typ===
Opcja Type pozwala na wybranie pięciu różnych sposobów określania długości, na jaką Pad będzie wyciągany.
====Dimension====
Podaj długość Pad-u. Domyślnie, kształt wyciągany jest "poza" bryłę, ale może to zostać zmienione wybierając opcje "Reversed". Extrusions occur [http://en.wikipedia.org/wiki/Surface_normal normal] to the defining sketch plane. Za pomocą opcji '''Symmetric to plane''' the pad will extend half of the given length to either side of the sketch plane

Latest revision as of 14:47, 5 November 2019

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (PartDesign Pad)
===Type===

Typ