Translations:PartDesign Bearingholder Tutorial II/26/en

From FreeCAD Documentation
Revision as of 12:01, 27 May 2014 by FuzzyBot (talk | contribs) (Importing a new version from external source)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
The body for the bolts

Create a revolution from the sketch and apply a fillet of 4mm to the top. This means that after machining away 3mm, a slight radius will remain which helps to avoid a sharp edge where someone could cut their hand when tightening the bolt.