Translations:Draft Wire/5/en

From FreeCAD Documentation
Revision as of 17:41, 25 September 2016 by FuzzyBot (talk | contribs) (Importing a new version from external source)

Options

  • If several connected Draft Lines are selected when pressing the Draft Wire Button, they will be turned into a wire and the command will exit. introduced in version 0.17
  • Press F or the Finish button to finish the wire, leaving it open
  • Press C or the Close button or click on the first point to finish the wire, but making it closed by adding a last segment between the last point and the first one.
  • Press X, Y or Z after a point to constrain the next point on the given axis.
  • To enter coordinates manually, simply enter the numbers, then press ENTER between each X, Y and Z component.
  • Press R or click the checkbox to check/uncheck the Relative button. If relative mode is on, the coordinates of the next point are relative to the last one. If not, they are absolute, taken from the (0,0,0) origin point.
  • Press T or click the checkbox to check/uncheck the Continue button. If continue mode is on, the Wire tool will restart after you finish or close it, allowing you to draw another one without pressing the Wire button again.
  • Press CTRL while drawing to force snapping your point to the nearest snap location, independently of the distance.
  • Press SHIFT while drawing to constrain your next point horizontally or vertically in relation to the last one.
  • Press W or press the Wipe button to remove the existing segments and start the wire from the last point.
  • Press CTRL+Z or press the Undo button to undo the last point.
  • Press I or the Filled button to have the wire filled with a face if it is closed.
  • Press ESC or the Cancel button to abort the current Line command.
  • Closed wires, when in "Flat Lines" display mode, can display a hatch pattern, by setting their "Pattern" property below.