Translations:Draft Rectangle/6/ro

From FreeCAD Documentation
Revision as of 15:42, 7 January 2019 by Mario52 (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Proprietăți

  • DATELength: Specifies the length of the rectangle
  • DATEWidth: Specifies the width of the rectangle
  • DATEChamfer Size: Specifies the size of chamfered corners
  • DATEFillet Radius: Specifies a curvature radius to give to the corners of the rectangle
  • DATERows: Allows to give horizontal subdivisions to this rectangle
  • DATEColumns: Allows to give vertical subdivisions to this rectangle
  • DATEMake Face: Fills the rectangle with a face
  • VEDERETexture Image: Allows to give the path to an image file to be mapped on the rectangle. It is up to you to give the rectangle the same proportion as the image if you want to avoid distortions. Blanking this property will remove the image.
  • VEDEREPattern: Specifies a hatch pattern to fill the wire with.
  • VEDEREPattern Size: Specifies the size of the hatch pattern