Translations:Draft Rectangle/6/ro: Difference between revisions

From FreeCAD Documentation
(Created page with "==Proprietăți== * {{PropertyData|Length}}: Specifies the length of the rectangle * {{PropertyData|Width}}: Specifies the width of the rectangle * {{PropertyData|Chamfer Size...")
 
mNo edit summary
 
Line 1: Line 1:
==Proprietăți==
==Proprietăți==
* {{PropertyData|Length}}: Specifies the length of the rectangle
* {{PropertyData/ro|Length}}: Specifies the length of the rectangle
* {{PropertyData|Width}}: Specifies the width of the rectangle
* {{PropertyData/ro|Width}}: Specifies the width of the rectangle
* {{PropertyData|Chamfer Size}}: Specifies the size of chamfered corners
* {{PropertyData/ro|Chamfer Size}}: Specifies the size of chamfered corners
* {{PropertyData|Fillet Radius}}: Specifies a curvature radius to give to the corners of the rectangle
* {{PropertyData/ro|Fillet Radius}}: Specifies a curvature radius to give to the corners of the rectangle
* {{PropertyData|Rows}}: Allows to give horizontal subdivisions to this rectangle
* {{PropertyData/ro|Rows}}: Allows to give horizontal subdivisions to this rectangle
* {{PropertyData|Columns}}: Allows to give vertical subdivisions to this rectangle
* {{PropertyData/ro|Columns}}: Allows to give vertical subdivisions to this rectangle
* {{PropertyData|Make Face}}: Fills the rectangle with a face
* {{PropertyData/ro|Make Face}}: Fills the rectangle with a face
* {{PropertyView|Texture Image}}: Allows to give the path to an image file to be mapped on the rectangle. It is up to you to give the rectangle the same proportion as the image if you want to avoid distortions. Blanking this property will remove the image.
* {{PropertyView/ro|Texture Image}}: Allows to give the path to an image file to be mapped on the rectangle. It is up to you to give the rectangle the same proportion as the image if you want to avoid distortions. Blanking this property will remove the image.
* {{PropertyView|Pattern}}: Specifies a hatch pattern to fill the wire with.
* {{PropertyView/ro|Pattern}}: Specifies a hatch pattern to fill the wire with.
* {{PropertyView|Pattern Size}}: Specifies the size of the hatch pattern
* {{PropertyView/ro|Pattern Size}}: Specifies the size of the hatch pattern

Latest revision as of 15:42, 7 January 2019

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Draft Rectangle)
==Properties==

Proprietăți

  • DATELength: Specifies the length of the rectangle
  • DATEWidth: Specifies the width of the rectangle
  • DATEChamfer Size: Specifies the size of chamfered corners
  • DATEFillet Radius: Specifies a curvature radius to give to the corners of the rectangle
  • DATERows: Allows to give horizontal subdivisions to this rectangle
  • DATEColumns: Allows to give vertical subdivisions to this rectangle
  • DATEMake Face: Fills the rectangle with a face
  • VEDERETexture Image: Allows to give the path to an image file to be mapped on the rectangle. It is up to you to give the rectangle the same proportion as the image if you want to avoid distortions. Blanking this property will remove the image.
  • VEDEREPattern: Specifies a hatch pattern to fill the wire with.
  • VEDEREPattern Size: Specifies the size of the hatch pattern