Sketcher: Dreptunghi

From FreeCAD Documentation
Revision as of 12:57, 2 January 2024 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Sketcher CreateRectangle

poziția meniului
Sketch → Sketcher geometries → Create rectangle
Ateliere
Sketcher
scurtătură
R
Prezentat în versiune
-
A se vedea, de asemenea,
Sketcher Polyline

Descriere

Desenează un dreptunghi definit prin două puncte diagonal opuse. Când pornește instrumentul, indicatorul mouse-ului se schimbă într-o cruce albă cu o iconițo cu un dreptunghi roșu. Coordonatele indicatorului sunt afișate lângă indicator în culoarea albastră și în timp real.

To define a rectangle via a center point and an edge point, use the Centered rectangle tool.

Cum se folosește

  • Duă ce apăsați butonul 'Create Rectangle', click o dată pentru a defini primul colț, apoi glisăm mouse-ul și click a doua oară pentru a stabili al doilea unghi/colț.
  • Apăsați tasta Esc sau click butonul drepta al mouse-ului pentru a abandona/anula această funcție.

Notes

  1. A Mode spinbox to chose one of the modes to draw the rectangle:
    • Corner, length & width
    • Center, length & width
    • 3 corners
    • Center and two corners
  2. A Rounded corners checkbox to apply round corners to the rectangle.
  3. A Frame checkbox to add a contour with a constant offset to the (rounded) rectangle.
  • All three buttons in this selection now launch the same tool but with different preset combinations of mode and options that can still be altered after the first click.
  • If Rounded corners is enabled, the offset is inward, and the offset value is larger than the corner radius, the offset contour will be created without fillets.
  • The modes 3 corners, and Center and two corners create parallelograms rather than rectangles.