Skicář Obdélník

From FreeCAD Documentation
Revision as of 12:57, 2 January 2024 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Skicář Obdélník

Umístění Menu
Náčrt → Skicář Konstrukce → Vytvořit Obdélník
Pracovní stoly
Skicář
Výchozí zástupce
R
Představen ve verzi
-
Viz také
Skicář Lomená čára

Popis

Tento nástroj nakreslí obdélník zadáním dvou protějších bodů. Při spuštění nástroje se ukazatel myši změní na bílý křížek s ikonou červeného obdélníku. Vedle jsou zobrazeny souřadnice v reálném čase.

To define a rectangle via a center point and an edge point, use the Centered rectangle tool.

Použití

  • Po stisknutí tlačítka Vytvořit Obdélník, klikněte nejdříve na místo prvního bodu, potom přesuňte myš a klikněte do místa druhého bodu v protějším rohu.
  • Stisknutím klávesy Esc nebo kliknutím na pravé tlačítko myši se funkce přeruší.

Notes

  1. A Mode spinbox to chose one of the modes to draw the rectangle:
    • Corner, length & width
    • Center, length & width
    • 3 corners
    • Center and two corners
  2. A Rounded corners checkbox to apply round corners to the rectangle.
  3. A Frame checkbox to add a contour with a constant offset to the (rounded) rectangle.
  • All three buttons in this selection now launch the same tool but with different preset combinations of mode and options that can still be altered after the first click.
  • If Rounded corners is enabled, the offset is inward, and the offset value is larger than the corner radius, the offset contour will be created without fillets.
  • The modes 3 corners, and Center and two corners create parallelograms rather than rectangles.