Sketcher CreatePolyline/es
Sketcher CreatePolyline |
Ubicación en el Menú |
---|
Croquizador→ Geometrías del croquizador → Crear polilínea |
Entornos de trabajo |
Croquizador |
Atajo de teclado por defecto |
Ninguno |
Introducido en versión |
- |
Ver también |
Línea |
Descripción
Esta herramienta trabaja como la herramienta Línea, pero crea segmentos de líneas continuos conectados por sus vértices.
Cuando se inicia la herramienta, el puntero del ratón cambia a una cruz blanca con un icono de polilínea rojo. Las coordenadas del puntero se muestran al lado de este en color azul en tiempo real.
Polyline started with a line, a tangent arc, a perpendicular arc then a tangent line
Utilización
The polyline always starts with a straight line segment: click - move the mouse - click. Move the mouse again. After placing the first line segment, the Sketcher polyline tool has multiple modes that can be toggled with the M key. For example you can draw tangent or perpendicular arcs following a line or arc segment. Repeatedly pressing the M key toggles through these different modes:
- Press the M key: the new segment is a line which is perpendicular to the previous segment.
- Press the M key again: the new segment is a line which is tangential to the previous segment.
- Press the M key again: the new segment is an arc which is tangential to the previous segment.
- Press the M key again: the new segment is an arc which is perpendicular (left) to the previous segment.
- Press the M key again: the new segment is an arc which is perpendicular(right) to the previous segment.
- Press the M key again: You are again in the state where you started; the line is only connected with a coincidence to the previous segment.
- v0.18 and above While in any of the arc modes, holding down the Ctrl key (MacOS: CMD key) and moving the cursor causes the arc to snap by increments of 45 degrees, relative to the previously created polyline segment.
- Pick points on an empty area of the 3D view, or on an existing object (auto constraints must be active in TaskView).
- Pressing Esc or clicking the right mouse button before closing the polyline to a loop ends the current polyline and you can continue with a new one. Pressing Esc or clicking the right mouse button again ends the polyline function.
- Pressing Esc or clicking the right mouse button after closing the polyline to a loop ends the polyline function.