Sketcher ConstrainDistanceY/cs: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Updating to match new version of source page)
Line 8: Line 8:
Zafixuje svislou vzdálenost mezi 2 body nebo konci přímek. Je-li vybrána pouze jedna položka, bude vzdálenost nastavena na původní hodnotu.
Zafixuje svislou vzdálenost mezi 2 body nebo konci přímek. Je-li vybrána pouze jedna položka, bude vzdálenost nastavena na původní hodnotu.
</div>
</div>

[[File:Sketcher ConstraintDistanceY example.png|none]]


<div class="mw-translate-fuzzy">
<div class="mw-translate-fuzzy">
Line 16: Line 18:
</div>
</div>


'''Note:''' the constraint tool can also be started with no prior selection, but will require selection of two points. To set the distance to the origin, the sketch origin point needs to be selected as well. By default the command will be in continue mode to create new constraints; press the right mouse button or {{KEY|ESC}} once to quit the command.
'''Note:''' the constraint tool can also be started with no prior selection, but will require selection of two points or one line. To set the distance to the origin, the sketch origin point needs to be selected as well. By default the command will be in continue mode to create new constraints; press the right mouse button or {{KEY|ESC}} once to quit the command.


{{clear}}
{{clear}}

Revision as of 03:59, 3 October 2018

Constraint VerticalDistance

Umístění Menu
Sketch → Sketcher geometries → Constrain vertical distance
Pracovní stoly
Náčrt, Návrh dílu
Výchozí zástupce
Nikdo
Představen ve verzi
-
Viz také
Vazba vodorovné vzdálenosti, Vazba délky

Popis

Zafixuje svislou vzdálenost mezi 2 body nebo konci přímek. Je-li vybrána pouze jedna položka, bude vzdálenost nastavena na původní hodnotu.

Použití

  1. Vyberte jeden nebo dva body
  2. Aktivujte vazbu

Note: the constraint tool can also be started with no prior selection, but will require selection of two points or one line. To set the distance to the origin, the sketch origin point needs to be selected as well. By default the command will be in continue mode to create new constraints; press the right mouse button or ESC once to quit the command.