Constraint PointOnPoint

From FreeCAD Documentation
Revision as of 21:08, 18 December 2013 by Renatorivo (talk | contribs) (Created page with ""Crea una restricción de coincidencia en los objetos seleccionados" ==Descripción== Esta restricción permite hacer dos puntos <em>coincidentes</em>.")

Constraint PointOnPoint

Ubicación en el Menú
Croquizador → Restricciones del Croquizador → Coincidente
Entornos de trabajo
Croquizador, Diseño de Piezas
Atajo de teclado por defecto
Ninguno
Introducido en versión
-
Ver también
Bloquear, Punto en objeto

"Crea una restricción de coincidencia en los objetos seleccionados"

Descripción

Esta restricción permite hacer dos puntos coincidentes.

Usage

As stated above, this tool takes two arguments - both are points.

  1. Firstly it is necessary to highlight two distinct points. (Note this will not work if, for example, you attempt to select the start and end point of the same line).
  2. Highlighting of a drawing item is achieved by moving the mouse over the item and clicking the left-mouse-button.
  3. A highlighted item will change colour to green.
  4. Subsequent items can be highlighted by repeating the above procedure(s) NOTE: There is no-need to hold-down any special key like Ctrl to achieve multiple item selection in a drawing.
  5. Once you have two points highlighted, left-clicking on the 'PointOnPoint' constraint will cause the two points to become coincident and be replaced by a single point.

NOTE: In order to make two points coincident, FreeCAD must necessarily move one, or both, of the original points.