Díl Koule

From FreeCAD Documentation
Revision as of 22:01, 3 September 2015 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Díl Koule

Umístění Menu
Díl -> Koule
Pracovní stoly
Modul Díl, Kompletace
Výchozí zástupce
Nikdo
Představen ve verzi
-
Viz také
Díl Vytváření zákl.geom.tvarů

Vytvoří jednoduchou parametrickou kouli podle parametrů pozice, úhel1, úhel2, úhel3 a poloměr.

How to use

In the workbench Part click on the sphere icon . The sphere will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of sphere instead of a full sphere (they are set to 360° by default).

Volby

The parametric sphere is defined by the following parameters:

  • Radius
  • Angle 1
  • Angle 2
  • Angle 3
  • as well as the standard set of placement parameters

The picture below gives an overview of a parametric sphere with parameters different from the default value.

Parameter

  • Radius: Radius of the sphere
  • Angle 1: 1nd angle to cut / define the sphere
  • Angle 2: 2nd angle to cut / define the sphere
  • Angle 3: 3rd angle to cut / define the sphere

Because it is quite difficult to explain the meaning of the parameters angle 1, angle 2, angle 3, the picture below gives an explanation about these parameters with following values: angle 1 = -45°, angle 2 = 45° and angle 3= 90°.