Part Cone/cs: Difference between revisions
(Created page with "== Popis == Parametricky zkrácený díl Kužel je dostupný v pracovní ploše Díl z nástrojového pruhu Díl, Menu Díl (submenu zákl.geom.tvary) a dialogové okno Vytv...") |
(Created page with "== Použití == V pracovní ploše Díl klikněte na ikonu kuželu 32px.") |
||
Line 4: | Line 4: | ||
Parametricky zkrácený díl Kužel je dostupný v pracovní ploše Díl z nástrojového pruhu Díl, Menu Díl (submenu zákl.geom.tvary) a dialogové okno Vytváření zákl.geom.tvarů. |
Parametricky zkrácený díl Kužel je dostupný v pracovní ploše Díl z nástrojového pruhu Díl, Menu Díl (submenu zákl.geom.tvary) a dialogové okno Vytváření zákl.geom.tvarů. |
||
== |
== Použití == |
||
V pracovní ploše Díl klikněte na ikonu kuželu [[Image:Part Cone.png|32px]]. |
|||
The default values create a truncated parametric cone, defined by radius1, radius2 height and angle, parameters. The default cone will be positioned at origin (point 0,0,0) on creation. The angle parameter permits the creation of a portion of cone (it is set to 360° by default), and the radius 1 and 2 correspond to base and top radius of the truncated cone. |
The default values create a truncated parametric cone, defined by radius1, radius2 height and angle, parameters. The default cone will be positioned at origin (point 0,0,0) on creation. The angle parameter permits the creation of a portion of cone (it is set to 360° by default), and the radius 1 and 2 correspond to base and top radius of the truncated cone. |
Revision as of 18:59, 14 July 2014
Díl Kužel |
Umístění Menu |
---|
Díl -> Kužel |
Pracovní stoly |
Díl, Kompletace |
Výchozí zástupce |
Nikdo |
Představen ve verzi |
- |
Viz také |
Díl Vytváření zákl.geom.tvarů |
Popis
Parametricky zkrácený díl Kužel je dostupný v pracovní ploše Díl z nástrojového pruhu Díl, Menu Díl (submenu zákl.geom.tvary) a dialogové okno Vytváření zákl.geom.tvarů.
Použití
V pracovní ploše Díl klikněte na ikonu kuželu .
The default values create a truncated parametric cone, defined by radius1, radius2 height and angle, parameters. The default cone will be positioned at origin (point 0,0,0) on creation. The angle parameter permits the creation of a portion of cone (it is set to 360° by default), and the radius 1 and 2 correspond to base and top radius of the truncated cone.
Options
The image below shows a Part Cone with the parameter "Angle" set to 270 degrees and all other parameters are at their default values.