Projekt Części: Subtraktywna elipsoida

From FreeCAD Documentation
Revision as of 05:35, 18 June 2023 by Kaktus (talk | contribs) (Created page with "Funkcja ta wstawia pierwotną elipsoidę odejmowaną od aktywnej Zawartości. Jej kształt jest odejmowany od istniejącej bryły.")

Projekt Części: Subtraktywna elipsoida

Lokalizacja w menu
Projekt Części → Utwórz cechę przez odjęcie → Subtraktywna elipsoida
Środowisko pracy
Projekt Części
Domyślny skrót
brak
Wprowadzono w wersji
0.17
Zobacz także
Komponent bryła pierwotna do odjęcia, Addytywna elipsoida

Opis

Funkcja ta wstawia pierwotną elipsoidę odejmowaną od aktywnej Zawartości. Jej kształt jest odejmowany od istniejącej bryły.

On the left: active body (A) shown in grey and subtractive ellipsoid (B) shown in transparent red; result on the right.

Usage

  1. Press the Subtractive Ellipsoid button. Note: the Subtractive Ellipsoid is part of an icon menu labelled Create an subtractive primitive. After launching FreeCAD, the Subtractive Box is the one displayed in the toolbar. To get to the Ellipsoid button, click on the down arrow besides the visible icon and select Subtractive Ellipsoid in the menu.
  2. Set the Primitive parameters and Attachment.
  3. Click OK.
  4. An Ellipsoid feature appears under the active Body.

Options

The Ellipsoid can be edited after its creation in two ways:

  • Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
  • Via the Property editor.

Properties

  • DANEAttachment: defines the attachment mode as well as the Attachment Offset. See Part EditAttachment.
  • DANELabel: label given to the Ellipsoid object. Change to suit your needs.
  • DANERadius1: the radius value along the ellipsoid's vertical axis; by default, parallel to the Z-axis.
  • DANERadius2: the radius value along the ellipsoid's length; by default, parallel to the X-axis.
  • DANERadius3: the radius value along the ellipsoid's width; by default, parallel to the Y-axis. At the default value of zero, the ellipsoid forms an oblate spheroid.
  • DANEAngle1: (labelled V parameter in the Primitive parameters) lower truncation of the ellipsoid, parallel to the circular cross section (-90 degrees in a full spheroid)
  • DANEAngle2: (unlabelled in the Primitive parameters) upper truncation of the ellipsoid, parallel to the circular cross section (90 degrees in a full spheroid).
  • DANEAngle3: (labelled U parameter in the Primitive parameters) angle of rotation of the elliptical cross section (360 degrees in a full spheroid).