Measurement Of Angles On Holes

From FreeCAD Documentation
Revision as of 12:47, 6 April 2020 by AnHi (talk | contribs)

</translate> </translate> </translate>

Introduction

To create angles for holes it's not possible to use vertical or horizontal center lines (false/true) from the properties of the view. Help lines or/and helping points are necessary.


Proceeding:

1.Setting center lines on holes:

There are some possibilities to create a center line for holes. At first the lines or points must be selected. Behind them the tool or from the tool bar is creating the center line. Please show the figures below.

File:AnHi3.png