Measurement Of Angles On Holes: Difference between revisions
Line 10: | Line 10: | ||
There are some possibilities to create a center line for holes. |
There are some possibilities to create a center line for holes. |
||
At first the lines or points on the hole must be selected. Behind them the tool |
At first the lines or points on the hole must be selected. Behind them the tool [[File:AnHi4.PNG]] or [[File:AnHi6.PNG]]from the tool bar is creating the center line. Please show the figures below. |
||
</translate> |
</translate> |
||
[[Image:AnHi3.PNG |
[[Image:AnHi3.PNG|200px|thumb|left|create center line by point to point]] |
||
<translate> |
<translate> |
Revision as of 15:48, 8 April 2020
Introduction
To creating angles for holes it's not possible to use vertical or horizontal center lines (false/true) from the properties of the view. Help lines or/and helping points are necessary.
Proceeding:
1.Setting center lines on holes:
There are some possibilities to create a center line for holes. At first the lines or points on the hole must be selected. Behind them the tool File:AnHi4.PNG or File:AnHi6.PNGfrom the tool bar is creating the center line. Please show the figures below.