Image Workbench/it: Difference between revisions

From FreeCAD Documentation
(Created page with "Category:User Documentation/it")
(Updating to match new version of source page)
Line 4: Line 4:


Il piano può essere spostato nello spazio 3D modificando il suo posizionamento nel [[Property editor/it|editor delle proprietà]]. Principalmente serve per costruire il tracciato di una nuova parte usando l'immagine come modello.
Il piano può essere spostato nello spazio 3D modificando il suo posizionamento nel [[Property editor/it|editor delle proprietà]]. Principalmente serve per costruire il tracciato di una nuova parte usando l'immagine come modello.

The image can be scaled by editing the "XSize" and "YSize" values in the [[Property editor]].

'''Tip:'''<br />
Tracing with sketcher elements over an image works best if the image has a small (negative) offset to the sketch plane.<br />
You can set an offset of -0,1 at import or later by editing the placement of the image.


{{Docnav/it|[[Raytracing Module/it|Ambiente Raytracing]]|[[Draft Module/it|Ambiente Draft - Disegno 2D]]}}
{{Docnav/it|[[Raytracing Module/it|Ambiente Raytracing]]|[[Draft Module/it|Ambiente Draft - Disegno 2D]]}}

Revision as of 03:13, 14 April 2015

Il modulo Immagine gestisce diversi tipi di immagini bitmap, e permette di aprirle in FreeCAD. Attualmente, il modulo consente di aprire file di formato .bmp, .jpg, .png e .xpm in una finestra di visualizzazione separata.

Il modulo Immagine consente inoltre di aprire una immagine su un piano nello spazio 3D di FreeCAD. Questa funzione è disponibile tramite il secondo pulsante dell'ambiente immagine.

Il piano può essere spostato nello spazio 3D modificando il suo posizionamento nel editor delle proprietà. Principalmente serve per costruire il tracciato di una nuova parte usando l'immagine come modello.

The image can be scaled by editing the "XSize" and "YSize" values in the Property editor.

Tip:
Tracing with sketcher elements over an image works best if the image has a small (negative) offset to the sketch plane.
You can set an offset of -0,1 at import or later by editing the placement of the image.