CAM ToolController: Difference between revisions
Renatorivo (talk | contribs) No edit summary |
(Marked this version for translation) |
||
Line 3: | Line 3: | ||
<translate> |
<translate> |
||
<!--T:1--> |
|||
A tool controller carries properties for how a tool should be used in one or more operations. |
A tool controller carries properties for how a tool should be used in one or more operations. |
||
<!--T:2--> |
|||
For example a tool, like a 1/4 inch cutter can run at many different spindle speeds and feed rates. The same tool might be used in different ways in the same job. |
For example a tool, like a 1/4 inch cutter can run at many different spindle speeds and feed rates. The same tool might be used in different ways in the same job. |
||
<!--T:3--> |
|||
properties: |
properties: |
||
<!--T:4--> |
|||
feed speed (h) |
feed speed (h) |
||
feed speed (v) |
feed speed (v) |
||
<!--T:5--> |
|||
rapid speed (h) |
rapid speed (h) |
||
rapid speed (v) |
rapid speed (v) |
||
<!--T:6--> |
|||
Spindle Speed (rpm) |
Spindle Speed (rpm) |
||
Spindle direction (forward/reverse) |
Spindle direction (forward/reverse) |
||
<!--T:7--> |
|||
Tool Number |
Tool Number |
||
Revision as of 13:59, 26 September 2019
This documentation is not finished. Please help and contribute documentation.
GuiCommand model explains how commands should be documented. Browse Category:UnfinishedDocu to see more incomplete pages like this one. See Category:Command Reference for all commands.
See WikiPages to learn about editing the wiki pages, and go to Help FreeCAD to learn about other ways in which you can contribute.
A tool controller carries properties for how a tool should be used in one or more operations.
For example a tool, like a 1/4 inch cutter can run at many different spindle speeds and feed rates. The same tool might be used in different ways in the same job.
properties:
feed speed (h) feed speed (v)
rapid speed (h) rapid speed (v)
Spindle Speed (rpm) Spindle direction (forward/reverse)
Tool Number