All translations
Enter a message name below to show all available translations.
Found 5 translations.
Name | Current message text |
---|---|
h English (en) | The next step is to create wires from each of our meshes. There is a convenient Macro named [[Macro_Extract_Wires_from_Mesh|Macro Extract Wires from Mesh]] that does just that. Install it (Refer to the [[Macros|Macros]] page for instructions), then one by one (you can do them all at once, but this macro takes some time), convert all our meshes to wire objects: |
h français (fr) | L'étape suivante consiste à créer des fils à partir de chacun de nos maillages. Il existe une macro pratique nommée [[Macro_Extract_Wires_from_Mesh/fr|Macro Extract Wires from Mesh]] qui fait exactement cela. Installez-la (consultez la page [[Macros/fr|Macros]] pour obtenir des instructions), puis, un par un (vous pouvez les faire tous en même temps, mais cette macro prend un certain temps), convertissez tous nos maillages en objets filaires : |
h italiano (it) | Il passo successivo consiste nel creare dei wire da ciascuno degli oggetti mesh. C'è una macro utile chiamata [[Macro Extract Wires from Mesh/it|Estrai wire da mesh]] che fa proprio questo. Installarla (Fare riferimento alla pagina delle [[Macros/it|macro]] per le istruzioni), poi uno ad uno convertire tutti i mesh in oggetti wire (si può fare tutto in una volta, ma questa macro richiede un po' di tempo): |
h polski (pl) | Następnym krokiem jest utworzenie polilinii z każdej z naszych siatek. Istnieje wygodna makrodefinicja o nazwie [[Macro_Extract_Wires_from_Mesh/pl|Extract Wires from Mesh]], które właśnie to robi. Zainstaluj je ''(instrukcje znajdziesz na stronie [[Macros/pl|Makrodefinicje]])'', a następnie po kolei ''(możesz zrobić wszystkie naraz, ale to makro zajmuje trochę czasu)'' przekonwertuj wszystkie nasze siatki na obiekty polilinii: |
h română (ro) | The next step is to create wires from each of our meshes. There is a convenient Macro named [[Macro Extract Wires from Mesh]] that does just that. Install it (Refer to the [[Macros]] page for instructions), then one by one (you can do them all at once, but this macro takes some time), convert all our meshes to wire objects: |