All translations

Enter a message name below to show all available translations.

Message

Found 5 translations.

NameCurrent message text
 h Deutsch (de)Der Referenzpunkt sollte in der Mitte des Abstands AB bleiben. Dies wird erreicht, indem zuerst die beiden Endpunkte des Abstands AB und als drittes der Mittelpunkt ausgewählt werden. Wenn alle drei Punkte in der richtigen Reihenfolge ausgewählt wurden, kann die Symmetriebedingungung durch Klicken auf die Schaltfläche [[Image:Sketcher_ConstrainSymmetric.svg|24px|link=Sketcher_ConstrainSymmetric/de]] gesetzt werden, wie unten dargestellt.
 h English (en)The reference point should stay at the center of the distance AB. This will be achieved by selecting first the two endpoints of the distance AB and third selecting the center point. When all three points are selected in the right sequence, the symmetry constraint can be set at clicking at the [[Image:Sketcher_ConstrainSymmetric.svg|24px|link=Sketcher_ConstrainSymmetric]] button, as shown below.
 h français (fr)Le point de référence doit rester au centre de la distance AB. Cet objectif sera atteint en sélectionnant d'abord les deux extrémités de la distance AB et en sélectionnant ensuite le point central. Lorsque les trois points sont sélectionnés dans le bon ordre, la contrainte de symétrie peut être fixée en cliquant sur le bouton [[Image:Sketcher_ConstrainSymmetric.svg|24px|link=Sketcher_ConstrainSymmetric/fr]], comme indiqué ci-dessous.
 h italiano (it)Il punto di riferimento deve rimanere al centro della distanza AB. Questo si ottiene selezionando prima le due estremità della distanza AB e poi, come terza selezione, il punto centrale. Quando si selezionano i tre punti nella giusta sequenza, il vincolo di simmetria può essere impostato cliccando sul pulsante [[Image:Constraint_Symmetric.png|32px]], come mostrato sotto.
 h polski (pl)Punkt odniesienia powinien pozostać w środku odległości AB. Zostanie to osiągnięte poprzez wybranie najpierw dwóch punktów końcowych odległości AB i trzeciego punktu środkowego. Po wybraniu wszystkich trzech punktów w odpowiedniej kolejności, można ustawić ograniczenie symetrii po kliknięciu przycisku [[Image:Sketcher_ConstrainSymmetric.svg|32px|link=Sketcher_ConstrainSymmetric/pl]], jak pokazano poniżej.