All translations

Enter a message name below to show all available translations.

Message

Found 5 translations.

NameCurrent message text
 h Deutsch (de)[[Image:HolderTop2-13.jpg|Die Skizze für den Körper für die Schrauben|thumb|right|400px]]
Die Schrauben benötigen zwei zylindrische Körper auf beiden Seiten des Hauptkörpers. Am besten ist es, den 2 Grad Entformungswinkel in die Skizze aufzunehmen. Ich habe versucht, einen Zylinder zu drehen und später einen Entwurf anzuwenden, aber nach dem Spiegeln passierten seltsame Dinge, und ich konnte keine Verrundungen anbringen, weil die Oberfläche irgendwie verzogen war.
 h English (en)[[Image:HolderTop2-13.jpg|The sketch for the body for the bolts|thumb|right|400px]]
The bolts need two cylindrical bodies on both sides of the main Body. It is best to include the 2 degree draft angle in the sketch. I tried revolving a cylinder and later applying a draft, but weird things happened after mirroring it and I couldn't put fillets on it because the surface was warped somehow.
 h français (fr)[[Image: HolderTop2-13.jpg | Le croquis pour le corps des boulons | thumb | right | 400px]] Les boulons ont besoin de deux corps cylindriques des deux côtés du corps principal. Il est préférable d'inclure l'angle de dépouille de 2 degrés dans l'esquisse. J'ai essayé de tourner un cylindre et d'appliquer plus tard un projet, mais des choses étranges se sont passées après la symétrie et je ne pouvais pas mettre les congés sur elle parce que la surface a été déformée en quelque sorte.
 h italiano (it)[[Image:HolderTop2-13.jpg|Sketch con il disegno della parte per i bulloni|thumb|right|400px]]
I bulloni hanno bisogno di due corpi cilindrici su entrambi i lati del corpo principale. E' meglio inserire lo sformo di 2 gradi nel disegno. Ho provato a creare un cilindro con una rotazione e applicarvi successivamente uno sformo, ma dopo il mirroring sono successe delle strane cose e non ho potuto applicarvi i raccordi, perché la superficie era in qualche modo deformata.
 h română (ro)[[Image:HolderTop2-13.jpg|The sketch for the body for the bolts|thumb|right|400px]]
The bolts need two cylindrical bodies on both sides of the main Body. It is best to include the 2 degree draft angle in the sketch. I tried revolving a cylinder and later applying a draft, but weird things happened after mirroring it and I couldn't put fillets on it because the surface was warped somehow.