Translations:Draft Ellipse/7/ro

From FreeCAD Documentation
Revision as of 12:59, 6 August 2018 by Luc (talk | contribs)
  • Pentru a introduce manual coordonatele, pur și simplu introduceți numerele, apoi apăsați ENTER between each X, Y and Z component.
  • Press T or click the checkbox to check/uncheck the
Continue button. If continue mode is on, the Ellipse tool will restart after you give the second point, allowing you to draw another ellipse without pressing the Ellipse button again.
  • Press CTRL while drawing to force snapping your point to the nearest snap location, independently of the distance.
  • Press SHIFT while drawing to constrain your second point horizontally or vertically in relation to the first one.
  • Press I or the Filled button to have the ellipse filled with a face after it has been closed
  • Press ESC or the Cancel button to abort the command.
  • Ellipses, when in "Flat Lines" display mode, can display a hatch pattern, by setting their "Pattern" property below.